ELISA Kit for Semaphorin 4D (SEMA4D)

This assay has high sensitivity and excellent specificity for detection of Semaphorin 4D (SEMA4D).
No significant cross-reactivity or interference between Semaphorin 4D (SEMA4D) and analogues was observed.

Matrices listed below were spiked with certain level of recombinant Semaphorin 4D (SEMA4D) and the recovery rates were calculated by comparing the measured value to the expected amount of Semaphorin 4D (SEMA4D) in samples.

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Semaphorin 4D (SEMA4D) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Semaphorin 4D (SEMA4D) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Semaphorin 4D (SEMA4D) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.